For operation
>> To operate one of the programmed devices with the URC first press the corresponding device button e.
Then point the URC to this device and press the desired button.
>> Put the number buttons o exactly as you do with the original remote control. Before you make a two digit entry press, if necessary, the 
button a.
>> Press the FAV/EPG button l to start the electronic pro- gramme guide of a device equipped with this function.
>> Whilst you hold down the S button r the date will be su- perimposed below to the right in the LCD display q.
>> Whilst you hold down one of the device buttons e the active code for this device will be superimposed below to the right in the LCD display q.
>> Via the MENU button j you access the dialogue for the setting of the respective target device.
All OFF
Tips:
With the button 
ALL OFF (all off) w all devices that are switched on can be automatically switched off. This func- tion can switch on again devices that have already been switched off (depending on the device). For this hold down the ALL OFF button w for approx. 5 seconds. This will only function under the following circumstances:
1.A visible connection exists between all the devices and the URC.
2.Automatic code search, brand code search and MACRO function are not active.
3.All target devices must be suitable for remote control switch off.
To again switch on all devices automatically hold down once more the button 
w until all devices are switched on.
Faults / Remedies
Your device does not react to the URC.
>> Check the batteries. They must have enough voltage and be properly installed.
>> Firstly have you pressed the correct device button e for the desired target device?
>> Check to see that the correct code is programmed in for the target device (see section "Code Setup").
The URC is transmitting the commands incorrectly.
>> Press the corresponding device button e to set the URC to the correct mode.
>> The batteries must have enough voltage and be properly installed.
- 21 -
