Safety notes / Operation
4.Careful handling and use of electrical power tools
a)Pull the mains plug from the socket before you make any adjustments to the device, change accessories or when the device is put away.
This precaution is intended to prevent you from unintentionally starting the device.
b)When not in use always ensure that electrical power tools are kept out of reach of children. Do not let anyone use the device if he or she is not familiar with it or has not read the instructions and advice. Electrical power tools are dangerous when they are used by inexperienced people. Let the device cool down completely before putting it away.
The hot nozzle can cause damage.
c)Look after the device carefully. Check that moving parts are working properly and move freely. Check for any parts that are broken or dam- aged enough to detrimentally affect the functioning of the device. Have damaged parts repaired before you use the device. Many accidents have their ori- gins in poorly maintained electrical power tools.
d)Always work with the mains lead leading away from the rear of the device.
QOperation
QBefore first use
Preparing the glue site:
JDo not use inflammable solvents to clean the glue site.
JThe ambient temperature and temperature of the materials to be glued must be not less than +5° C and not warmer than +50° C.
JThe glue sites must be clean, dry and free of
grease.
jSmooth surfaces should be roughened before gluing.
20 GB/MT
jWarm any materials that are prone to cool down quickly (e.g. steel) to improve the bond with the glue.
jScrew on the appropriate nozzle 8 and fit the wire stand 6 .
QPreparing the tool for use
Working with the mains lead connected:
1.Connect the mains lead 11 to the glue gun connection 10 (see Fig. F).
Insert the mains plug into the mains socket.
2.Fold forward the wire stand 6 Stand the device up.
3.Push a glue stick into the feed channel 1 .
4.Let the device heat up for about 4 minutes. The device is now ready for use.
Cordless working:
1.Connect the mains lead 11 to the charger connection 3 .
Insert the mains plug into the mains socket.
2.Place the glue gun into the charger.
3.Push a glue stick into the feed channel 1 .
4.Let the device heat up for about 4 minutes. The device is now ready for use.
5.Repeat the
Gluing:
jPress the feed switch 5 to regulate the flow of glue as required for your work.
1.Apply the glue in individual dots. Apply in zig- zags on flexible materials such as fabrics.
2.Immediately after applying the glue, press the two materials together for about 30 seconds. The glued joint can be loaded after about 5 minutes.
3.When you take a break from work, set the glue gun down on the wire stand 6 or in the charger.
4.Remove any glue residue with a sharp knife af- ter cooling. Glued joints can be loosened again by applying heat.
