Original ancillaries / accessories | Kompernass PEBH 1010 specs

General safety advice for electrical power tools / Preparing for use

footing and balance, hold the hammer drill firmly with both hands and use the auxiliary handle 9 .

JWear safety glasses and a

dust mask! POISONOUS DUSTS! Working with harmful / noxious dusts represents a risk to the health of the person op- erating the device and to anyone near the working area.

JDo not drill any material containing asbestos. Asbestos is a known carcinogen.

JDo not allow the ventilation slots to become covered while the device is operating. Do not insert any objects into the ventilation slots.

QAttention! Service lines!

Warning! Take steps to ensure that . you do not hit upon any service lines (electricity, gas, water) when working with electrical appliances. Check, if need be with a service line detector, before you start to cut or bore into a surface.

QOriginal ancillaries / accessories

JUse only the ancillaries and accessories that are detailed in the operating in- structions. The use of ancillaries and acces- sories other than those recommended in the operating instructions could lead to an increased risk of personal injury for you.

QAssembling the Additional Handgrip

Note: For safety reasons this device may only be used when the additional handgrip 9 is correctly assembled (see also Fig. D, E).

jAttach the additional handgrip 9 to the spindle neck and turn it in an anticlockwise direction until it is tight.

QDepth stop

jSetting the depth stop 10 in the auxiliary han- dle 9 .

jSet the required drilling depth by sliding the depth stop 10.

QInserting / Removing Tools

Inserting a Tool:

jBefore inserting the tool, apply a small amount of grease to the tool holder 1 .

jIn order to insert the tool, pull the locking / un- locking cap 3 to the rear and insert the tool.

jRelease the locking / unlocking cap 3 . This locks the tool holder in place. Pull the tool to ensure that it is firmly locked in place. The tool has some radial play inherent in the system.

Removing a Tool:

jIn order to remove the tool, pull the locking / unlocking cap 3 to the rear.

QPreparing for use

Note the mains voltage! The voltage of the mains socket must match that shown on the rating plate on the device (Devices marked with 230 V~ can also be operated at 220 V~).