Kompernass PEBH 1010 Preparing for use / Maintenance and Cleaning / Disposal, Switching on / off

Preparing for use / Maintenance and Cleaning / Disposal

QSelecting the Angle of Rotation

Select the direction of rotation by setting the rotation

direction switch		7	.
			Do not use or set the rotation
	Warning!
direction switch		7	unless the device has come to a
standstill.

QPre-selecting the Speed

With the wheel on the speed pre-selector 6 you can pre-select the operating speed to your individu- al requirements.

If a low speed has been pre-selected, the ON / OFF switch 4 is automatically restricted in the extent to which it can be pulled back (due to the reduced speed of rotation).

Recommended speed ranges: (non-binding; if necessary, you should determine the correct setting by a practical test):

-High-speed: for hammer drilling in concrete or stone and for chiselling

-Medium speed: for drilling into steel or wood

-Low speed: for screwing

Low speed / high speed:

jTurn the wheel for speed pre-selection 6 .

The ON / OFF switch 4 has a variable speed control.

jBy pressing the switch you can increase the speed continuously.

QSwitching on / off

When operating the hammer drill you can choose between temporary and permanent operation. Use the temporary operation for small jobs and perma- nent operation for long jobs. Your desired setting is operated as follows:

Switching on temporary operation:

jPress the ON / OFF switch 4 .

12 GB/IE/CY

Switching off temporary operation:

jRelease the ON / OFF switch 4 .

Switching on permanent operation:

jPress the ON / OFF switch 4 and lock it in the on position by means of the locking button 5 .

Switching off permanent operation:

jPress the ON / OFF switch 4 and release it again.

QMaintenance and Cleaning

Warning! DANGER OF INJURY! Always pull the mains plug out of the socket before doing any work on the device.

jAlways keep the device clean, dry and free of oil or grease.

jNo liquids must be allowed to enter the hammer drill.

jClean the hammer drill regularly, preferably always immediately after finishing your work.

jPlease use a dry cloth for cleaning the housing. Under no circumstances should you use petrol, solvent or cleaning agents which might attack the plastic.

jClean the tool holder 1 regularly. CAUTION! UNDER TENSION! To do so, pull the locking / unlocking cap 3 towards the rear and lever off the rubber dust protection cap 2 . Release the locking / unlocking cap 3 slowly.

jClean the components with a brush and apply a small amount of grease to them.

QDisposal

The packaging is wholly composed of environmentally-friendly materials that can be disposed of at a local recycling centre.

Do not dispose of electrical power tools with the household rubbish!