Introduction / General safety advice for electrical power tools
Fixed mounting kit:
12Mounting frame
13Clamp plates 2 x
14Screw clamps 2 x
15Spacer plates 2 x
16Screw
QIncluded items
Check that all the items and accessories are present immediately after unpacking the device:
1 Belt sander PEBS 900
1 Sanding belt
1 Dust collection box
1 Extraction adapter
(for external vacuum dust extraction)
1 Fixed mounting kit
1 Operating instructions
1 Booklet “Guarantee and service”
Warning! The vibration level given in these instructions has been measured in accordance with a standardised measurement procedure specified in EN 60745 and can be used to compare devices. Different uses of the device give rise to different vibra- tion levels and in many cases they may exceed the values given in these instructions. It is easy to underes- timate the vibration load if the electrical power tool is used regularly in particular circumstances.
Note: If you wish to make an accurate assessment of the vibration loads experienced during a particu- lar period of working, you should also take into account the intervening periods of time when the device is switched off or is running but is not actual- ly in use. This can result in a much lower vibration load over the whole of the period of working.
The PEBS 900 belt sander has
QTechnical information
Belt sander: | Parkside PEBS 900 |
Nominal voltage: | 230 V ~ 50 Hz |
Nom. power input: | 900 W |
| |
n0 | |
Sanding belt | 75 x 533 mm |
Protection class: | II / |
Noise and vibration data:
Values determined in accordance with EN 60745. The sound pressure level
Wear ear protection!
Total vibration, EN 60745:
Vibration emission value ah, D = 2.828 m / s2 Uncertainty K < 1.5 m / s2
General safety advice for electrical power tools
Warning! Read all the safety advice and instructions!
Failure to observe the safety advice and instructions may result in electric shock, fire and/ or serious injury.
KEEP ALL THE SAFETY ADVICE AND INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE!
GB/IE/CY 7
