7Gear selector switch
8Auxiliary handle
9
Parts that can be replaced by the user:
a)Auxiliary handle
b)Depth stop
If these parts become damaged or lost please contact the service centre for your country in order to replace them. For safety reasons, this applies especially to the auxiliary handle as this device may be used only with the auxiliary handle.
Introduction
Noise / Vibration data
Values determined in accordance with EN 60745. The sound pressure level
Included items
|
|
|
| Wear ear protection! |
1 | Hammer action drill PSBM 1100 |
|
| |
1 | Auxiliary handle |
|
|
|
1 | Depth stop |
| Total vibration (vector sum of three directions) is | |
1 | Carrying case |
| calculated in accordance with EN 60745: | |
1 | Operating instructions |
|
| |
1 | Booklet containing „General safety advice” | Drilling in metal: | ||
1 | Booklet covering „Warranty and service“ | Vibration emission value ah,D = 3,2 m / s2 | ||
|
|
| Uncertainty K = 1,5 m / s2 | |
| Technical information | |||
|
|
| Vibration emission value ah,ID = 19,313 m / s2 | |
Nominal voltage: | 230 V ~ 50 Hz | Uncertainty K = 1,5 m / s2 | ||
Nom. power input: | 1100 watts |
|
| |
No load speed: | Clockwise: |
| Warning! The vibration level given in | |
| ||||
|
| 1st gear |
| these instructions has been measured in |
|
| 2nd gear |
| accordance with a standardised |
Impact cycles: | max. 51.000 / min | measurement procedure specified in EN 60745 | ||
Chuck capacity: | max. ø 13 mm | and can be used to compare devices. Different | ||
Drill | max. 32 mm | uses of the device give rise to different vibration lev- | ||
Drill | max. 50 mm | els and in many cases they may exceed the values | ||
Drill | max. 30 mm | given in these instructions. It is easy to underesti- | ||
Drill | max. 25 mm | mate the vibration load if the electrical power tool | ||
Drill | max. 13 mm | is used regularly in particular circumstances. | ||
Protection class: | II / & |
|
| |
Hand / arm vibration: | 11 m / s2 |
|
|
GB/IE 7