Safety
Safety
Safety advice relating specifically to this device
JKeep children away from the device.
Store the device indoors in an en- closed, dry place where it cannot
be reached by children.
To avoid danger to life from electric shock:
JFrequently check the condition of the
device, mains lead and plug. Do not 
use the device if these kinds of parts are damaged. Never open up the device. Always have any repairs carried out or replacement parts fitted at the service centre or by an elec- trical equipment repair specialist. A damaged device, mains lead or plug presents a serious danger to life from electric shock.
JHave repairs carried out only by an electrician or your service centre.
JDo not touch the mains lead if it becomes damaged or cut through while you are using the device. Pull the plug out of the mains socket immediately and have the device repaired by a suitably qualified person or at your service centre.
JDo not operate the device if it is damp and do not use it in a damp environment.
JIf you use the device outdoors, always connect it through a residual current device (RCD) with a maximum trip current of 30 mA. If using an extension lead, always use one that is ap- proved for outdoor use.
JDo not use the device in rain or in wet conditions.
JDo not work in areas where there may be hidden electricity cables or gas or water pipes. Use a suitable detector or ask your local utility service providers. Contact with electricity cables can lead to fire or electric shock. Damaging a gas pipe can lead to an explosion. Penetration
8 GB/IE
of a water pipe can lead to property damage or to electric shock.
Attention! To avoid the risk of injury:
JWear protective glasses, hearing
protection (noise can lead to hearing loss), dust protection mask and
protective gloves. Please note that working on stone or metal can give rise to hazardous dusts that can adversely affect your health.
JBe particularly careful when screwing in longer screws - the driver could slip off the screw head.
JUse the auxiliary handle supplied with the device. Loss of control of the tool can lead to injury.
JSecurely support the workpiece. Use clamps or a vice to grip the workpiece firmly. This is much safer than holding it in your hand and it means you then have both hands free to operate the electrical power tool.
Working safely!
JIf a dangerous situation arises, pull the mains plug immediately out of the mains socket.
JNever use the device for a purpose for which it was not intended.
JBefore you insert the mains plug into the socket, always check that the device is switched off.
JAlways keep proper footing and balance.
JWhen taking a break from your work, before carrying out any tasks on the device itself and when you are not using the device, always pull the mains plug out of the mains socket.
JHandle the device carefully and treat it with respect. Always keep the device clean, dry and free of oil or grease.
JRemain alert at all times! Always watch what you are doing and proceed with caution.
JDo not use the device if you cannot concen- trate or you are feeling unwell.
