Operation / Maintenance and Cleaning / Disposal
Preselecting the rotation speed
You can preselect the required speed using the speed preselector wheel 5 .
jYou can increase or decrease the speed by turning the speed preselector wheel. The most suitable speed depends on the material involved. We recommend that you carry out a few practical tests beforehand.
Tip: You will always find these two basic guidelines helpful:
1.Large drill diameter = lower speed whilst smaller drill diameter = higher speed
2.Hard material = lower speed
Selecting the direction of rotation
Caution! Only change the position of the rotation direction switch after the tool has come to a standstill.
jSet the direction you wish the drill to rotate by using the rotation direction switch 6 .
Note: The tool operates at lower speeds when rotating in the counter clockwise direction.
Selecting the gear
Caution! The gear selector switch must only be moved after the drill has come to a standstill.
jSelect between the following speed ranges using the gear selector switch 7 :
1 = low speed range 2 = high speed range
Selecting drill / hammer drill action
Caution! Only change the setting of the drill / hammer drill action switch after the tool has come to a standstill.
jSelect the appropriate operating mode using the drill / hammer action selector switch 1 :
Drilling:
jSet the switch 1 to the right on to the drill symbol.
Hammer drilling:
jSet the switch 1 to the left on to the hammer symbol.
Note: The hammer drill action mode is intended for drilling into brick, concrete and stone only.
Maintenance and cleaning
Attention! Before carrying out any tasks on the device itself and when you are not using the device, always pull the mains plug out of the mains socket.
The device is largely
jAlways keep the device and the ventilation slots clean.
jClean the device frequently. For best results, clean the device immediately after you have finished using it.
jDo not allow any liquids to enter the device. Use a soft cloth to clean the device.
jDo not under any circumstances use petrol or strong solvents.
jStore the device in a dry room.
Disposal
The packaging is wholly composed of
centre.
10 GB/IE
