Maintenance and care
Cleaning or Replacing the filter continued
Use only genuine BISSELL replace- ment filters in your BISSELL vacuum. To purchase visit WWW.BISSELL.COM or call
To clean filter:
1. | Turn power OFF (O). |
|
2. | Remove the dirt container from the hand |
|
| vacuum, as directed in step 1 "Emptying |
|
| the dirt cup" on page 6. |
|
3. | Remove filter and tap firmly against the | 3. |
| inside of a waste container, removing | |
|
|
any visible dirt.
4.Replace filter back into the dirt container and attach dirt container to hand vacuum until it snaps securely in place.
NOTE: After heavy usage, you may clean the filter by washing it gently by hand in warm water and mild dish detergent. Rinse thoroughly and make certain it is completely dry before replacing it.
Brush roll and brush roll belt maintenance
The brush roll may accumulate debris such as strings, hair and fibers. This type of debris can wrap around the brush and diminish its ability to clean effectively.
To remove brush roll for cleaning:
1. Turn power OFF (O). Remove foot 2. assembly from unit and turn over to
access the brush roll.
2.Remove three Phillips head screws to remove the belt cover.
3. | To remove brush roll, pull on the brush |
|
| near the belt side. Clean off hair or |
|
| other debris from brush roll. |
|
4. | Place cleaned brush roll back into foot | 3 |
| of unit by aligning the |
|
it's seated in the nozzle.
5.Pivot the brush roll so the belt end slides into the slot in the nozzle.
6.Replace the belt cover and secure with three screws. Attach foot assembly on unit.
4.
7
w w w. b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |
