CE- Conformity
This device complies, in regards to conformance with the basic requirements and other relevent regulations, with the EMC Directive 2004/108/EC, as well as the Directive for Low Voltage Devices 2006/95/EC.
Description of the appliance
Appliance (Fig. A) 1 Cutting head
2 Suspension loop
3 On/Off switch
4 Adjusting lever
Trimming guides and accessories (Fig. B) 1/8“ (3 mm Cutting length)
1/4“ (6 mm Cutting length) 3/8“ (9 mm Cutting length) 1/2“ (13 mm Cutting length) Trimming guide for side step cut (right) Trimming guide for side step cut (left) Blade cover
Cleaning brush Blade oil
Operation
The fur to be cut must be dry and clean. Brush the fur through to remove any knots.
•Remove the blade guard from the cutting head 1.
•Place the required trimming guide (- )
with the prongs facing upwards on the cutting head 1 and thereby press the flap of the trim- ming guide down firmly onto the lower metal edge of the cutting head (see illustration).
•Ensure that the trimming guide has properly engaged and is secured before starting to cut/ trim the fur.
Note:
It is recommended that you begin by trimming a small area to test the individual trimming guides. Start with a trimming guide for long fur and, if neces- sary, change to a shorter one. The trimming guides allow an average cutting length from
•Switch the appliance on by sliding the On/Off switch 3 to the position „ON“.
•Slowly run the appliance through the fur against the direction of hair growth. Hold the appliance so that the trimming guide is as flat as possible against the animal.
•Additionally, using the adjusting lever 4, the cutting depth of the cutting head 1 can be adjusted stepwise (approx. 2 mm) without changing the trimming guide.
To do this, press the adjusting lever 4 back- wards to increase the cutting length in steps. Through this, the cutting length of the respective attached trimming guide will also be increased by up to 2 mm.
Press the adjusting lever 4 forwards to reduce the cutting length or to bring the trimming guide back into its original position.
•Through removal of the individual trimming guide, i.e. using only the cutting head 1 itself, you can cut clean contours.
•After use, switch the appliance off by sliding the On/Off switch 3 to the position „OFF“.
Cleaning and Care
Risk of electric shock
Before cleaning, remove the plug from the mains power socket.
NEVER submerse the appliance in water or other liquids.
•Take the respective trimming guide, if fitted, off.
•Using exclusively the cleaning brush , remove the hairs from the cutting head 1. The cutting head 1 may not be cleaned with water or other liquids, except medical alcohol!
•If in regular use, the cutting head 1 should be oiled occasionally. For this, use the supplied
blade oil .
•Remove excess oil with a dry cloth.
•Clean the housing with a soft, dry lint-free cloth.
•Store the appliance in a dry and dust free location. When it is in storage, place the blade
guard | on the cutting head 1. |
- 3 -
