SELF-TIMER

Used for self-portraits, the self-timer will delay the release of the shutter for approximately ten seconds after the shutter-release button is pressed. The self-timer is set with the drive-mode button (p. 32).

With the camera on a tripod, compose the picture as described in the basic

1

recording operation section (p. 25). Focus lock ( 26) can be used with off-center

 

subjects. Press the shutter-release button partway down to lock the exposure and

 

focus (1). Press the shutter-release button all the way down to begin the

 

countdown (2). Because focus and exposure are determined when the shutter-

 

release button is pressed, do not stand in front of the camera when taking a self-

2

timer image. Always confirm the focus with the focus signals before beginning the

countdown (p. 27).

 

During the countdown, the self-timer lamp on the front of the camera (3) will start

 

to blink and is accompanied by an audio signal. A few

 

seconds before the exposure, the self-timer lamp will blink

 

rapidly. The lamp will glow steadily just before the shutter

 

fires. To stop the countdown, press the drive-mode button.

 

The self-timer is canceled after the exposure. The audio

 

signal can be turned off in the custom 1 section of the setup

 

menu (p. 84).

 

3

Shooting tips

The self-timer can be used to minimize camera shake with long exposures. When using the camera on a tripod, photographs of static subjects (landscapes, still-lifes, or close-up pho- tographs) can be made with the self-timer. Because no contact is made with the camera during exposure, there is no risk of camera shake caused by the operator.

33