9Press OK/ENTER. The Choose your Picture Mode screen opens.
Choose your Picture Mode
Home Mode
Retail Mode
OK | MENU PREVIOUS | EXIT EXIT |
MOVE ENTER SELECT |
Reduces total power consumption
10Press 
or 
to highlight Home Mode (default) or Retail Mode, then press OK/ENTER.
If you selected Retail Mode, a message appears “Are you sure you want Retail mode? Since in this mode Energy saving is not realized.” Select Yes to continue, or select No to change your selection.
The Choose your TV source screen opens.
Choose your TV source
Understanding the basics
Note
Unless otherwise noted, all tasks in this section are based on using the remote control.
Turning your TV on or off
To turn your TV on or off:
1Make sure that the power cord is connected to a power outlet.
2Press 
(power) to turn on your TV. The power indicator LED turns blue.
3Press 
(power) again to turn off your TV. Your TV enters Standby mode and the power indicator LED turns red.
Warning
When your TV is in Standby mode, it is still receiving power. To completely disconnect power, unplug the power cord.
Note
If your TV does not receive an input signal for several minutes, it automatically goes into Standby mode.
| Antenna | 0 | Digital Channels | |
|
| |||
| Cable |
|
|
|
| Cable/Satellite box | 0 | Analog Channels | |
|
|
|
| |
|
| Scanning for digital channels | ||
MOVE | OK |
| PREVIOUS | EXIT EXIT |
ENTER SELECT | MENU | |||
Channel scan may take 20+ minutes
11Press 
or 
to highlight Antenna, Cable, or Cable/Satellite Box (if your cable TV uses a box, select Cable/Satellite Box), then press OK/ENTER. If you chose Antenna or Cable, your TV automatically starts scanning for channels available in your viewing area. If you chose Cable/Satellite box, your TV does not need to scan for channels.
During auto channel search, your TV searches for digital channels first. If you chose Antenna, when the digital channel search is complete, a message appears asking if you want to search for analog channels. If you do not need to search for analog channels, press MENU or EXIT stop searching for channels.
When the scan is complete, the Setup Wizard closes automatically.
Note
You can press EXIT to stop the auto channel search, but you will need to run the auto channel search again to create a channel list.
Selecting the video input source
To select the video input source:
1Turn on your TV, then press INPUT. The Source List opens.
Source List
TV
Component
VGA
HDMI 1
HDMI 2
HDMI 3
HDMI 4
USB
2Press 
or 
to highlight a video input source, then press OK/ENTER.
You can also press a direct input button to select the video input source.
•Press TV to select TV.
•Press COMP to select Component.
•Press HDMI once to select HDMI 1.
•Press HDMI twice to select HDMI 2.
•Press HDMI three times to select HDMI 3.
•Press HDMI four times to select HDMI 4.
Note
If Auto Input Sensing is set to On, only the jacks that have connected devices are active. The other inputs are grayed and cannot be selected.
14 | www.insigniaproducts.com |