Sequencer P8: Insert Effect 8–1: MIDI Routing1

509

Sequencer P8: Insert Effect
You can also specify the bus routing for the program
used by each MIDI track 1–16 and audio track 1–16.
For instance, you can:
• Send the output of a track to an insert effect
• Route a sound to an insert effect
• Make detailed settings for insert effects
• Make common LFO settings for effects
For details on Insert Effects, see “Effect Guide” on
page 727.
8–1: MIDI Routing1
Specifies the bus to which the program oscillator(s)
used by each MIDI track 1–16 will be sent. You can also
set the send levels to the master effects from this page.
8–1a: Routing Map
This area shows the insert effect routing, the name of
the assigned effect, the on/off status, chaining, and the
output bus that follows the insert effect. The type of
insert effect, the on/off status, and the chain settings
can be edited in the P8– Insert FX page.

8–1b: MIDI Routing1

Track 01 (Track Number)
Bus Select (IFX/Indiv. Out Assign) Dkit [Off, On]
You can select this only if the specified program is a
drum program (Oscillator Mode Drums).
This parameter can also be edited from the P8– MIDI
Routing 2 page.
1–1a
1–1b
8–1a
8–1b
8–1PMC