Kramer Electronics C-AFDM user manual Using Your Optical All-Fiber DVI Cable

Using Your Optical All-Fiber DVI Cable

4Using Your Optical All-Fiber DVI Cable

This section describes how to:

￿￿Install the Optical All-Fiber DVI Cable (see section 4￿ .1)

￿￿Avoid pitfalls when using it (see section 4￿ .2)

4.1Installing Your Optical All-Fiber DVI Cable

To connect the Optical All-Fiber DVI Cable, do the following:

1.Carefully remove your Optical All-Fiber DVI Cable from its packaging.

2.Connect an AC/DC power adapter to the receiver module (see Figure 2)

Figure 2: Optical All-Fiber DVI Cable – Receiver Module

3.Plug the Transmitter module of the Optical All-Fiber DVI Cable directly into the DVI receptacle of the computer.

The Optical All-Fiber DVI Cable uses only the power +5V supplied through a DVI pin (#14) from the graphic card.

Figure 3: Optical All-Fiber DVI Cable – Transmitter Module

4.Plug the Receiver module of the Optical All-Fiber DVI Cable into the DVI display receptacle.

5.Turn ON the power on both the computer and the display device.

You can replace any DVI cable or an Optical All-Fiber DVI Cable with another Optical All-Fiber DVI Cable by following the above procedures while the computer and display device are powered up.

4 KRAMER: SIMPLE CREATIVE TECHNOLOGY