SPK-C612 - Installing the SPK-C61 2 Cl osed -back Ceiling Speakers 7
7
Do not nail or staple the speaker wires.
If you are mounting the speakers onto a ceiling til e, remove the ceiling ti l es where
you plan to install the speakers. Use the templat e to trace and then cutout the
speaker hole over an empty box.
The closed-back ceiling speakers are supported by the ceiling mounting kit (two
C-rings and two pairs of tile rails; the tile rails prevent the speakers from falling if
the tile itself comes out or falls apart, as their ends catch onto the T-grid). When
mounting onto the ceiling ti l es, use both supports.
Be sure that the tiles can support the speaker. Small er sized tiles or
fiberglass-t ype til es c annot support the weight of the speakers.
When this is the case, the speakers will need additional support.
When mounting onto a sheetrock ceiling, t he C-ring alone is used to reinforce the
ceiling material.
5.3 Mounting the Speakers
To mount the SPK-C612, do the following:
1. Place the C-ring over the hole cut in the ceiling tile (on the “ceiling” side).
Place it around the hole so that the tabs are located in parallel to the tile
edges.
Figure 4: Mounting the SPK-C612
!
i