Kramer Electronics TP-114

Configuring a TP-114 XGA/HD Line Transmitter – DA System

1. On the TP-114, connect the XGA/HD source (for example, a computer

graphics/HD source) to the XGA IN 15-pin HD connector, and connect the

line output RJ-45 connector1:

 OUT 1 connector to the LINE IN RJ-45 connector on the first

TP-120

 OUT 2 connector to the LINE IN RJ-45 connector on the second

TP-120

 OUT 3 connector to the LINE IN RJ-45 connector on the third

TP-120

 OUT 4 connector to the LINE IN RJ-45 connector on the fourth

TP-120

2. On the four TP-120 units, connect the:

 XGA OUT 15-pin HD connector of the first TP-120 unit to the

XGA/HD acceptor (for example, display 1)

 XGA OUT 15-pin HD connector of the second TP-120 unit to the

XGA/HD acceptor (for example, display 2)

 XGA OUT 15-pin HD connector of the third TP-120 unit to the

XGA/HD acceptor (for example, display 3)

 XGA OUT 15-pin HD connector of the fourth TP-120 unit to the

XGA/HD acceptor (for example, display 4)

3. On each Kramer TOOL, connect the 12V DC power adapter to the power

socket and connect the adapter to the mains electricity.

The signal from the XGA source is transmitted via the CAT 5 cables,

decoded and converted at the each of the XGA OUT 15-pin HD connectors

to the XGA acceptors.

4. On the TP-120 units, if necessary:

 Set the H SYNC and V SYNC switches2 on the underside

 Adjust3 the video output signal level and/or cable compensation

equalization level

5. On the TP-114, if necessary, set the VS and HS switches4 on the underside

1 Via UTP cabling (with a range of more than 300ft (>100m)). For details of how to wire a CAT 5 LINE IN/LINE OUT

RJ-45 connector, see section 5.1

2 By default, both switches are set down (for negative V SYNC and H SYNC polarity)

3 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level

4 By default, both switches are set down (to NORMAL) to retain the VS and HS polarity