36 | Optional Equipment |
Rear Blower Installation (Part # 99000138)
The rear blower improves heat transfer by pushing heated air through the convection channel. Operating instructions are described in the section "Blower Operation".
1The stove should be in place with the legs installed prior to installing the rear blower.
2 Follow the directions below to install the blower. Use the
Use the wire clip to insure the wires from the thermodisk are held in place away from the firebox (this prevents damage to the wires).
Thermodisk
This portion hooks on the top edge of the rear heat shield.
Wire Clip
This portion of the wire clips slides over the rear heat shield
The wires pass through the eye of the wire clip.
Blower Box | The two yellow wires | |
attach to the thermodisk. | ||
|
Three holes for attaching the blower box to the back of the stove
Slide the thermodisk assembly into the space between the stove and rear heat shield.
Run both of the wires from the thermodisk down behind the stove and through the eye of the wire clip.
Wire Clip
Power Cord (exits from back of blower box)
FRONT
© Travis Industries | 4041115 |