Lopi Liberty Wood Stove Chimney Termination Requirements, Outside Air Requirements, 100-01164

Stove Installation (for qualified installers only) 11

Chimney Termination Requirements

•Must have an approved cap (to prevent water from entering)

•Must not be located where it will become plugged by snow or other material

•Must terminate at least 3' above the roof and at least 2' above any portion of the roof within 10' (see Figure 5)

Slanted Roofs

Chimney must extend 3' above the roof

Flat

Chimney must extend 3' above the roof

Chimney must extend 2' above any portion of the roof within 10' of the chimney

Chimney must extend 2' above any portion of the roof within 10' of the chimney

Figure 5

Outside Air Requirements

•Required for mobile homes & in certain localities (check with building officials)

•Must not be drawn from an enclosed space (garage, unventilated crawl space)

•Requires the optional outside air boot (for legs) or pedestal

When using outside air, find a location where the chimney and outside air hole do not interfere with structural members of the home

Pedestal (with insulation) directs air to the stove

Air may be drawn from a ventilated crawl space or use an air duct.

A hole must be cut
through the floor	Outside
protection and floor	Air Boot
and the rodent
screen nailed in
place here (see the
optional equipment
instructions for
exact sizes)

Optional Air Duct (must not be longer than 15' and at least 16 square inches in cross section)

Outside air entrance must be placed so it does not become blocked by snow.

Figure 6

© Travis Industries 100-01164 4041115