Lopi Liberty Wood Stove Mobile Home Requirements, Travis Industries, 100-01164, 4041115

Stove Installation (for qualified installers only) 13

Mobile Home Requirements

•Outside air must be installed - see "Outside Air Requirements" on page 11

•Chimney connector and chimney must be one of the following types:

AMERI-TEC model DCC with model HS chimney

DURAVENT model DVL with DURATEC or DURA-PLUS chimney

METALFAB model DW connector with TG chimney

SECURITY model DP connector with SECURITY model ASHT or S2100 chimney

Standard Masonry Chimney with any one of the above listed connectors

NOTE: Reduced clearance connectors may not connect to the flue collar – an appliance adapter may be required.

•Stove placement must maintain the following clearances to combustibles (drywall, furniture, etc.)

		Rear heat
b	e	shield	c
a

d

f

c

Measure all clearances from the nearest edge of the stove top.

Minimum Clearance		Reduced Clearance
(See the illustration above)		Connector
A	Sidewall to stove	16"
B	Backwall to stove	10"
C	Cornerwall to stove	7-1/2"
D	Connector to sidewall	27-1/2"
E	Connector to backwall	12-3/4"
F	Connector to cornerwall	18-1/2"

•If using offsets, use the connector clearance listed in Figure 9, not the connector manufacturer's clearance.

• The appliance must be secured to the floor (consult your building official). Secure the outside air boot to the floor and stove to insure the stove does not dislocate.

•Mobile home installations require a spark arrester at the

chimney termination.

• The appliance must be grounded to the chassis of the mobile home (consult your building official).

• WARNING:DO NOT INSTALL IN SLEEPING ROOM.

•CAUTION:THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR, WALL, AND CEILING/ROOF MUST BE MAINTAINED.

Figure 8

12” Min.

Minimum Connector Clearance

(as outlined above)

Minimum Stove Clearance

(as outlined above)

Figure 9

© Travis Industries 100-01164 4041115