Your
Table 1: VP-108 1:8 XGA / Balanced Stereo Audio DA Features
# | Feature | Function |
1 | POWER Switch | Illuminated switch for turning the unit ON or OFF |
2 | AUDIO INPUT Terminal Block | Connect to the balanced stereo audio source |
| Connector |
|
3 | XGA INPUT | Connect to the XGA source |
4 | LEFT LEVEL Trimmer | Adjust1 the left output signal level |
5 | RIGHT LEVEL Trimmer | Adjust1 the right output signal level |
6 | LOOP | For looping to increase output availability |
7 | OUTPUT Terminal Block Connectors | Connect to the balanced stereo audio acceptors (from 1 to 8) |
8 | OUTPUT | Connect to the XGA acceptors (from 1 to 8) |
9 | REMOTE Terminal Block Connectors | Connect to the contact closure switches |
10 | ||
11 | Connect to PC or other Serial Controller | |
12 | SETUP Dipswitches | Dipswitches for setup of the unit |
13 | Power Connector with Fuse | AC connector enabling power supply to the unit |
Figure 2 and Table 2 define the underside controls:
| Figure 2: |
| Table 2: |
|
|
Feature | Function |
ID BIT Switch | Set to ON position2 to select the ID BIT3 |
TERMINATION4 Switch | Set to ON position2 to terminate with 75, or move to |
EQ.4 Trimmers | Adjust1 the cable compensation equalization levels for blue, green and red |
LEVEL4 Trimmers | Adjust1 the output signal levels for blue, green and red |
1 Insert a screwdriver into the small hole and carefully rotate it 2 The factory default
3 Sometimes notebook computers refuse to output a VGA signal to an external VGA monitor if they do not detect the ID BIT as ON. Set the ID BIT to ON using this switch so that the notebook will output to an external VGA monitor
4 Separately for Blue (B), Green (G) and Red (R)
5
