Kramer Electronics VP-419xl Video To SXGA/HD Scaler Front Panel Features, Feature Function

			Your VP-419xl Video to SXGA/HD Scaler
		Table 1: VP-419xl Video To SXGA/HD Scaler Front Panel Features
#			Feature	Function
1	POWER Switch			Switch for turning the unit ON or OFF
2	RGB/RESET Button			Illuminates when the output resolution is set to RGB. Press to set output
				to Y Pb Pr (the button no longer illuminates). Press and hold for more
				than 3 seconds to reset to VGA. Press and hold for 10 seconds to reset
				to 480p
3	IR Receiver			Lights when receiving signals from the remote control transmitter
4			MENU Button	Displays the OSD menu (see section 6￿ .2)
5	CONTROL		ENTER Button	Press to accept changes and change the SETUP parameters (see
				section 6￿ .2.3)
6			+ Button	Press to go up the menu list or adjust the PICTURE submenu values
				(see section 6￿ .2.2)
7			- Button	Press to go down the menu list or adjust the PICTURE submenu values
				(see section 6￿ .2.2)
8	INPUT SELECTOR		CV Button	Press to select the composite video source
11			SXGA Button	Press to select the SXGA source
9			YC Button	Press to select the s-Video (YC) video source
10			COMP. Button	Press to select the component video source

Table 2: VP-419xl Video To SXGA/HD Scaler Rear Panel Features

#		Feature	Function
12		YC 4p Connector	Connects to the s-Video source
13	INPUTS	CV RCA Connector	Connects to the composite video source
14		Y RCA Connector
15		CB RCA Connector	Connects to the interlaced1 component video source2
16		CR RCA Connector
17		SXGA PASS HD15 Connector	Connects to the VGA/Y, Pb, Pr source3
18	SXGA / HD OUT HD15 Connector		Connects to the SXGA or HDTV (component video)
			acceptor
19	12 VDC		+12V DC connector for powering the unit

1 Not compatible with progressive scan Y, Pb, Pr or HDTV

2 For component video, connect all three connectors: Y, Cb, Cr (also known as YUV)

3 This PC input signal is not scaled, but is available for pass-through when the PC source is selected

5