Krell Industries KAV2250 Amplifier Factory Default Settings, Reconfiguration Options, Warranty

Reconfiguration Options, continued

Accessing the Input Switch Banks, continued

6.Reconfigure your amplifier, using the scenarios described below.

7.After the component is configured, replace the cover and, using the T-15 Torx wrench, secure all 12 cover screws.

IMPORTANT

Operating the amplifier without the cover properly replaced and secured may void your

Warranty.

AMPLIFIER FACTORY DEFAULT SETTINGS

See Figure 5 on page 16

The KAV–2250 amplifier is shipped with input switch banks set to the following factory defaults:

1.For input switch bank 1: switch 1 up (on), switch 2 down (off).

2.For input switch bank 2: switch 1 down (off), switch 2 up (on).

The KAV–3250 amplifier is shipped with input switch banks set to the following factory defaults:

1.For input switch bank 1: switch 1 up (on), other switches down (off).

2.For input switch bank 2: switch 2 up (on), other switches down (off).

3.For input switch bank 3: switch 3 up (on), other switches down (off).

RECONFIGURING THE AMPLIFIER FOR MAT OPERATION

Reconfiguring the KAV–2250 for MAT: Send One Input Signal to Both Output Channels via Input 1

See Figure 6 on page 17

To send the signal from a source device connected to input 1:

1.Push switch 1 up (on) for both input switch banks.

2.Push switch 2 down (off) for both input switch banks.

18 Krell KAV–2250 and KAV–3250