KPS-20 BASIC OPERATION
Below are instructions for a quick installation of the
the Typical System Setup illustrations on pages 24, 25, and 26. Also, allow the unit to settle at room temperature before operation is started.
1. Plug the | the standard | wall | AC receptacle. | Connect | the | |||||||
output | to | the | appropriate | location: | input; | |||||||
amplifier | or | crossover | input; | to | D/A processor | input. | Engage | the | ||||
power | switch | on the | rear | panel | by | pushing | it up to the | ON position. | This | |||
powers | the | processor | sections in the |
|
|
2. Press the Power button on the front panel or on the remote control to power
the transport stages. The display section will now illuminate. The processor portion of the
switch is engaged. This is to insure thermal stability and improve sonic performance.
3. Press the Open/Close button on the front panel and the top cover assembly
will open, exposing the CD transport and spindle. Place the compact disc, label side up, onto the drive spindle. Place the five point custom clamp onto the drive spindle, securing the CD in place. Make sure the clamp is centered firmly on the custom CD spindle hub. Press the Open/Close button again or Play and the cover will close.
NOTE: In the event that you wish to rapidly change a number of CDs, the
marked "Manual~Auto" to the "Manual" position..The
quality of the music when the CD is exposed to light. Also, it is always preferable to close the cover when playing music at a high volume in order to maintain optimum tracking.
4.Press Play on the front panel or remote control. Note: if you pressed Play in step 3 the disc will already be playing. The disc will start playing from track 1. To select a 'different track you can press the track forward {> I} or track back {I <} button until you reach the desired track number or punch the number of the desired track into the keypad on the front panel or rem'ote control.
5.Press the Stop button to stop play.
7