UNPACKING AND PLACEMENT
1.Once the box is opened and top layer of foam removed, the following items will be visible:
1
1
1
1AC power cord
1
1Packet containing the Owner's Reference and Warranty
Registration Card
NOTE: If any of these items are not included, please contact your authorized dealer immediately for assistance.
2. Carefully remove the unit and accessories from the box. Remove the protective plastic wrap from the unit.
NOTE: Save all packing materials. If you must ship your
approved | packing material. |
|
|
|
|
|
|
| |||
PLACEMENT |
|
|
|
|
|
|
|
|
|
| |
Before | you | install | the | your | system, | we | |||||
recommend that | you | follow | these guidelines | in choosing | the location. | This | will | ||||
facilitate | a clean, | installation. | The | not require any | type | ||||||
of special | rack | or | cabinet |
| for | installation. | Dimensions | are described | on page | 27. |
1.Place the unit on a firm level surface away from excessive heat, humidity or moisture. Make sure there is enough room at the top for a compact disc to be placed within the chassis. Approximately ten inches is necessary.
2.Although well shielded, the
to
The power supply may create interference and induce hum.
3.The
require | additional | mass coupling or isolation. | You may experiment with feet or |
cones | as long as | they don't permanently affix | to the chassis. Any unauthorized |
modifications to the electronics or chassis will void the warranty.
4