Krell Industries KRC-HR Theater-Throughputsetup, SETTING THE $4 INPUT FOR THROUGHPUTFUNCTIONS

THEATER-THROUGHPUT SETUP

NOTE: If	the	KRC-HRmust		be handled after			the	top cover has	been removed,
the unit	must be held		only	on the	sides	of	the	chassis. Never	move the KRC-HR
while the	top	cover is	off by holding		the	front	panel.

When reinstalling the top cover, insert the four screws into the chassis sides first and lightly tighten them. Install the screws in the top surface and tighten

them lightly. Then tighten all screws firmly, starting with the side screws and finishing with the top screws.

SETTING THE $4 INPUT FOR THROUGHPUTFUNCTIONS

This procedure should be done with the unit OFF.

a. Remove the KRC-HR top cover screws with the T-15 Torx wrench supplied.

b. Locate the switch towards the front of the board that is labeled S4/Proc. Set the dip switch to the proc (processor) position.

NOTE: The default position of this switch sets the $4 input for standard operation. In this position, $4 is identical to the S1, $2 and $3 inputs.

c. Place the top cover back on the KRC-HRand insert the cover screws.

©

©	~	Proc.
	¯	¯
	¯	¯
	¯	¯
	¯	¯
	¯	¯
	¯	¯
	¯	¯
	¯	¯
	¯	¯
	¯	¯

4