BASIC INSTALLATION
1.Place the unit on a firm level surface free from excessive dirt or moisture.
The
be placed on or around it. If the optional phono card is installed in the
2.Place the power supply in a location away from hum sensitive components
such as turntables or phonostages. Connect the male | end | of the | DC power | |
cable into the | of | the | supply. | DO NOT |
PLUG THE POWER SUPPLY INTO THE AC OUTLET AT | THIS TIME. |
|
3.Connect the female end of the DC power cable to the
CAUTION: ALWAYS CONNECT THE DC CABLE TO THE BACK OF THE
SUPPLY INTO THE WALL OUTLET. FAILURE TO FOLLOW THE
CONNECTION SEQUENCE WILL CAUSE DAMAGE TO THE
4. Plug the AC cord into the receptacle on the back of the power supply. Plug the remaining end into the wall ACreceptacle.
NOTE: While the
dedicated AC circuit, we strongly advise against any connections through
extension cords or multiple AC adaptors. High quality 15 amp line conditioners or grounded AC strips are acceptable.
5. When the
a. The volume control will automatically rotate to the Off position, fully counterclockwise.
b. The Select section LEDs on the
c. The Protection relays will open once the monitoring circuits have
determined there are no input or output disturbances. See the PROTECTION CIRCUITRYsection of this manual for more information.
6. The
5