MovingCoil Cartridges:' The
~recommendations first. You can also set the load using your sonic preferences as a guide. In general, lowering the impedance will make the high frequencies less prominent and the overall sound warmer. Higher
loads makethe overall sound more vivid and detailed. This is, of course, highly ~ubjective and very dependent on the cartridge in use.
The various load possibilities are detailed below:
all switches in the open position = 47,000 ohms
all | switches | open except 8 on | = | 1,000 | ohms | |
all | switches | open except 7 on | = | 800 | ohms | |
all | switches | open except 6 on | = | 470 | ohms | |
all | switches | open except 5 on | = | 250 | ohms | |
all | switches | open except 4 on | = | 100 ohms | ||
all | switches | open except 3 | on | = | 47 | ohms |
all | switches | open except 2 | on | = | 25 | ohms |
all | switches | open except I | on | = | 10 ohms | |
all | switches | on |
| = | 5 | ohms |
Moving Magnet Cartridges: To set the Phono section for Moving Magnet operation, with the impedance adjusted to 47,000 ohms, set the phono gain switch towards the front of the preamplifier. This lowers the gain of the phono section to compensate for the higher output of moving magnet cartridges. Set all impedanceswitches for both channels to off.
C.INSTALLATION
1. Cautions!
Note: These are important points of which you always should be aware. They are presented before the actual installation procedures, should you not
read through the manual entirely.
a.Do not connect the power cord into the ACmains before completing the "Installation" section!
b.The power amplifier(s) should always be turned off while making connections.
4