Co Wheninstalling th'e KSP-7B,always connect the DCcable between the
preamplifier chassis and the power supply before plugging the power supply into the ACmains.
d.Alwaysdisconnectthe AC fromthe mainsbeforedisconnectingthe DC cablefromthepreamplifier.
e. The KSP-7BSelect switch should be in the Mute position and the volume control fully counterclockwise while making connections.
Our custom RCAconnectors are made to very exacting standards. Connectors of lesser quality may damage them or cause poor
connections. Please check with your dealer or the factory if you have any questions.
2. Unit Location Guidelines and Installation
The KSP-7Bis designed to be set-up with the power supply installed at some distance from the preamplifier chassis. This is to eliminate the possibility of hum being induced into the phono section. The motors in CDplayers or tape decks can also induce huminto the phono section and, in most cases, should be placed at least a foot away from the KSP-7B.
Before proceeding with the final installation, please read and complete the set-up of the phono section loading. These operations involve removal of the top cover and are much easier to accomplish before the unit is fully in place. Instructions and settings are listed in Section B (Pages 2 &3).
a. Power Supply Location Guidelines
The KSP-7Bpower supply measures 7 1/4" wide, 8 1/4" deep and 2 1/2" high. Six foot ACand DCcables are provided with the supply. Plan the position of the supply and preamplifier within these lengths. Allow a small amountof cable to be excess so that neither cable is pulled tight.
Contact the factory if the DCcable is too short. Anyattempt to extend it jeopardizes the power supply and the preamplifier and will void the unit's warranty.
Although well-shielded, the power supply should not be placed close to
hum-sensitive components such as turntables, phono preamplifiers or tape decks.
Allow ample air space around the supply for heat dissipation. Five inches on top and two inches on each side is adequate. This supply and any other should not be placed one on top of the other. They should be placed side-to-side.
