(SECTION FOUR: Connections and Configurations continued)
Step III. Configure the Programmable Electronic Crossover
This section explains how to configure the subwoofer’s two sections, the
Configuring the programmable electronic crossover is required for stereo and stereo/LFE operation. Krell recommends performing the configuration in the order indicated below.
A. Select the Low-pass Filter
Press the section sub key (35) on the remote control to access the
B. Select the Low-pass Filter Profile
Press the type key (39) to access the filter profile. Press the adjust keys (43) to select the profile you want. The Master Reference Subwoofer has three
C. Adjust the Low-pass Filter Parameters
IMPORTANT
Adjust the parameters in this order: slope, frequency, and level.
1.Low-pass Filter Slope
a.Press the slope key (40).
b.Use the adjust keys (43) to adjust the slope (in 6 dB increments). The
2.Low-pass Filter Frequency
a.Press the frequency key (41).
b.Use the adjust keys (43) to select the desired frequency setting (in 10 Hz increments). The frequency selectable ranges from 30 to 100 Hz.
36