(SECTION FOUR: Connections and Configurations continued)
Step IV. Match the
This section explains how, once the programmable electronic crossover has been configured, to match the
Step A describes muting the
A. Adjust the High-pass Filter
1.Press the menu key (37). The front panel display (4) shows MENU.
2.Use the up adjust key (43) to select NOISEGEN.
3.Press the enter key (38). The display shows NOISEOFF.
4.Press the up adjust key to select NOISE ON.
5.Press the enter key. After a two second delay, you will hear noise generator output through both the Master Reference Subwoofer and your front speakers.
6.Use the up adjust key to select MUTE. The front panel display shows MUTE.
7.Press the enter key. The front panel display shows the current setting for mute.
8.Press the up adjust key to select LPF ONLY.
9.Press the enter key.
10.Press the menu key to exit the menu mode.
11.Press the mute key (34) on the remote control to mute the
12.Press the section high key (36).
13.Press the level key (42).
14.Use the adjust keys to raise or lower the
15.Make sure you unmute the
38