Connecting to the RS-232 Port
WIRING THE MALE RS-232 PORT CONNECTOR
A
Refer to the operating manual of your external
To wire the male connector, follow these steps:
1.Locate the pin numbers on the male connector plug (not shown).
2.Locate the pinout numbers on the female connector. (See Pinout Signal list below).
3.Wire the male connector, matching the pin numbers on the connector plug to the pinout numbers on the female connector. Only three signals are necessary: 2=Received Data, 3=Transmitted Data, and 5=Signal Ground.
| 5 4 3 2 1 |
FEMALE CONNECTOR
(located on the back panel
of the Home Theater Standard 7.1)
9 8 7 6
Pinout Signal
1Data Carrier Detect
2Received Data
3Transmitted Data
4Data Terminal Ready
5Signal Ground
6Data Set Ready
7Request to Send
8Clear to Send
9Ring Indicator
RS-232 Port Protocols
The Home Theater Standard 7.1
9600 Baud | 8 Data Bits | 1 Stop Bit | No Parity |
4 | Krell Home Theater Standard 7.1 Developer’s Reference |