Connecting to the RS-232 Port
WIRING THE MALE RS-232 PORT CONNECTOR
RS-232 PORT FEMALE CONNECTOR
Located on the back panel of the SACD Standard
A
Refer to the operating manual of your external
To wire the male connector, follow these steps:
1.Locate the pin numbers on the male connector plug (not shown).
2.Locate the pinout numbers on the female connector. (See Pinout Signal list below).
3.Wire the male connector, matching the pin numbers on the connector plug to the pinout numbers on the female connector. Only three signals are necessary: 2=Received Data, 3=Transmitted Data, and 5=Signal Ground.
5 4 3 2 1
Pinout Signal
1 Data Carrier Detect
2 Received Data
3 Transmitted Data
4 Data Terminal
9 8 7 6
Ready
5 Signal Ground
6 Data Set Ready
7 Request to Send
8 Clear to Send
9 Ring Indicator
RS-232 Port Protocols
The SACD Standard
9600 Baud | 8 Data Bits | 1 Stop Bit | No Parity |
4 | Krell SACD Standard Developer’s Reference |