PROGRAMMING THE KA1000RR MEMORY
To program the KA1000RR, press and hold the light switch but- ton on the KA1000RR (figure 2.1). While holding the light switch button, press and hold the transmitter test button until the LED on the light switch button turns off then on one time. The transmit- ter ID is now recorded into memory of the receiver. To test if the KA1000RR has accepted the transmitter, press the transmitter test button to see if the unit begins to flash. To stop the flashing of the lamp, press the lamp switch button once.
If the light switch button flashes twice when programming the KA1000RR, the memory is full. Check the number of registered transmitters or erase any unused transmitters if needed.
2
