Air Motor Component Installation | Graco 332574D instruction

Repair

Air Motor Component

Installation

1.Lubricate o-rings and install the air motor into the muffler housing.

NOTICE

To avoid damage to the o-rings caused by the threads of the air motor, insert the air motor as shown below.

r_258899_3a0232_6k

2.Orient the nut bearing cap upside down and install the plunger with o-ring, spring, and washer.

r_258899_3a0232_3a

3.Screw the air motor assembly on the nut bearing cap. Torque to 120-140 in-lb (14-16 N•m).

r_258899_3a0232_5k

4.Use an arbor press to push the muffler housing down until it is flush with the bearing cap.

Correct

Incorrect

r_258899_3a0232_4a

5.Perform Air Motor Replacement, page 17, to com- plete the installation.

16

332574D

Image 16

Graco 332574D important safety instructions Air Motor Component Installation

Contents

Important Safety Instructions RS Gun Cutter Assemblies Contents Related Manuals Component Identification Key Anvil to Blade Tension Lockdown Setup Cutter Assembly Anvil and Blade ReplacementSee Replace Anvil and Replace Blades procedures on pages 11 Operation Adjust Cutter Speed Adjust Anvil to Cutter Head Tension Adjust Blower Air Adjust Anvil to Idler Tension Adjust Cutter Air PressureNumber Strands Metric Air Motor Oiling MaintenanceTask Schedule Adjust Anvil to Cutter Head Tension, Replace Anvil Replace Blades Replace Chopper Chute Liner Replace Muffler Filters Kit 24H280 Troubleshooting Repair Air Motor Component Removal Air Motor Component Installation Air Motor Replacement Parts Qty Ref Part DescriptionPart Description Qty Ti21021a Ring Air Motor, 24E511 Part Description Qty Accessories Cover and Chutes Blade CartridgesCutter Chute Liner, 16P833 Tools Cutter Head Kits Technical Data RS Cutter Assemblies Metric Graco Standard Warranty Graco Information