Air Motor Replacement

Repair

1.Verify o-ring (603) is installed between the back plate (601) and the air motor (602).

NOTICE

The air motor will not function properly if the air motor is installed incorrectly. In the following step, ensure the air motor is installed as described.

2.With the air motor and back plate oriented as shown below, use four screws (604) to secure them

together.

Two air holes align with the “X” as shown.

602

603

ti17689a

604 601

332574D

Page 17

Image 17

Graco 332574D important safety instructions Air Motor Replacement

Contents

RS Gun Cutter Assemblies Important Safety Instructions Contents Related Manuals Key Component Identification Anvil to Blade Tension Lockdown Setup Anvil and Blade Replacement Cutter AssemblySee Replace Anvil and Replace Blades procedures on pages 11 Operation Adjust Anvil to Cutter Head Tension Adjust Cutter Speed Number Strands Metric Adjust Anvil to Idler Tension Adjust Cutter Air PressureAdjust Blower Air Task Schedule MaintenanceAir Motor Oiling Replace Anvil Adjust Anvil to Cutter Head Tension, Replace Blades Replace Muffler Filters Kit 24H280 Replace Chopper Chute Liner Troubleshooting Air Motor Component Removal Repair Air Motor Component Installation Air Motor Replacement Parts Part Description Qty Ref Part DescriptionQty Ti21021a Ring Air Motor, 24E511 Part Description Qty Accessories Blade Cartridges Cover and ChutesCutter Chute Liner, 16P833 Tools Cutter Head Kits RS Cutter Assemblies Metric Technical Data Graco Information Graco Standard Warranty