Krown Manufacturing PCM3512

CHAPTER 1 (CONT.)

USING YOUR POCKETCOMM AS AVCO DEVICE

WITH MOBILE.

The PocketComm has a built-in microphone on top left of the

unit (Figure 2). If you are a Voice Carry Over user, you need

to set up the machine as a VCO unit. First, turn on the

PocketComm and press (CTRL)+(V). The display will read

‘[VCO ON]’. If the display reads “[VCO OFF]”. Second,

continue to press space bar to reset the unit. Go back to step

one to set up the VCO mode. Press (CTRL)+(S) to make sure

the status of VCO mode is on.

{Press CTRL-S to check status of the unit}

[NORMAL] [VCO ON] MICROPHONE

[MOBILE] [MIX] [45B]

After you initialize the unit, you can make a VCO call. To make a VCO call: First, plug the

mobile phone communication cable to the PocketComm and the other end to the mobile phone.

Second, turn on the PocketComm. Third, turn on the mobile phone and dial the number you want

to dial on the mobile phone keypad. Watch the LED signal for a proper ring cycle. If you see the

LED blinking with an irregular cycle, someone may have answered you by voice. Fourth, at this

time, press (CTRL)+(0) to send the VCO message. The message being sent says, “VCO CALL

PLS GA.” Fifth, after you receive the response from the operator and signal to start your voice,

speak clearly the number you want to dial to the microphone on the top left of the PocketComm

(See Figure 3). Always end the sentence by saying ‘Go Ahead’to let the agent know that you are

finished. Turn off the PocketComm and hang up the mobile phone after each use. The

PocketComm will retain the set up until you change it again. Therefore, you need to check the

status of the unit anytime you have problems making a phone call by pressing (CTRL)+(S). Make

sure you are in the right set up mode.

For more convenience, you can wear the mobile phone in your pouch when holding the

PocketComm to speak and read.

ACOUSTIC COUPLING YOUR POCKETCOMM AS A VCO TO A LANDLINE PHONE

Your PocketComm is designed for the best convenience. If you are a VCO user and need to use a

landline phone to make a call:

1. Turn on the PocketComm.

2. Press (CTRL)+(M) to switch mode to acoustic mode. If you see the display read:

’[MOBILE]’, press the space bar to reset the unit and go back to step 1 to set up the

PocketComm to work in acoustic mode.

3. Press (CTRL)+(V) to turn off the built-in VCO microphone in acoustic coupling. You

will speak directly to the mouthpiece of the handset.

4. Strap the elastic band onto the earpiece of the handset.

5. Dial the VCO Relay number on the keypad of the phone. Watch for the correct ring

process on the PocketComm signal LED.

6. The conversation has begun after the agent asks you to voice the number you want to

dial. Speak clearly to the handset mouthpiece and not the pocketComm since the

VCO mode now is off. (Figure 4)

FIGURE 3