22
5000TROPR 005893 R022504
It is extremely important that the following lubrication guide be followed:
For lubricating bearings, use a good quality multipurpose grease. Replace all damaged or missing grease zerks
immediately. Always clean zerks before using grease gun. Pump the grease in slowly until a slight bead forms
around the bearing seals. Once a month check lines and connections on grease banks for leaks.
The gear drive enclosure is designed to be used as an oil bath. With the unit level, fill oil bath through dipstick
until the oil level reaches the notch on the dipstick. 5032, 5042 & 5055 require 25 approximately gallons, 5073,
5085 & 50100 require approximately 30 gallons of 30wt detergent oil.
INPUT SHAFT
BEARINGS: GREASE
EVERY 20 HOURS
UNIVERSAL JOINT
ASSEMBLY: GREASE
EVERY 20 HOURS
4:1 GEARBOX:
(1000 RPM only) EP140W,
3:1 GEARBOX: EP90W,
CHECK EVERY 20 HOURS,
CHANGE YEARLY
DOOR GUIDES:
GREASE
EVERY 20 HOURS
PTO IMPLEMENT DRIVELINE JOINTS & SLIDE: GREASE, 8-10 HOURS
PTO IMPLEMENT DRIVELINE SHIELD: GREASE, EVERY 3 MONTHS
LUBRICATION:MAINTENANCE
ALWAYS STOP MIXER, SHUT OFF TRACTOR ENGINE AND REMOVE DRIVELINE BEFORE
SERVICING, REPAIRING, OR CLEANING. IF WORK MUST BE PERFORMED INSIDE THE MIXER, PUT
A PROTECTIVE COVER OVER THE AUGER KNIVES TO AVOID INJURY. THE HOPPER FLOOR AND
FLIGHTING MAY BE SLIPPERY. USE CAUTION WHEN STEPPING OR STANDING INSIDE THE UNIT.
USE SAFE SHOP PROCEDURES AND EXERCISE CAUTION WHEN WORKING ON THIS MIXER!