5000TROPR 005893 R022504
MIXER SETUP
IMPORTANT! READ BEFORE OPERATING MIXER.
IT IS THE RESPONSIBILITY OF THE OWNER TO MAKE SURE THE MIXER IS SET
UP PROPERLY. THE FOLLOWING RECOMMENDATIONS SHOULD BE HELPFUL
UNIT | EMPTY UNIT WT. + LOAD WT. = GROSS WT. | TRACTOR WEIGHT AT UP TO 20 MPH |
5032 | 8,200 +______________ =______________ | 2/3 OF GROSS WT. = TRACTOR WT. |
5042 | 9,650 +______________ =______________ | 2/3 OF GROSS WT. = TRACTOR WT. |
5055 | 10,800 +______________=______________ | 2/3 OF GROSS WT. = TRACTOR WT. |
5073 | 17,000 +______________= _____________ | 2/3 OF GROSS WT. = TRACTOR WT. |
5085 | 21,500 +______________=______________ | 2/3 OF GROSS WT. = TRACTOR WT. |
50100 | 22,000 +______________=______________ | 2/3 OF GROSS WT. = TRACTOR WT. |
|
|
|
A tractor with the above recommended weight for your unit is normally adequate for towing the loaded mixer under average conditions. Unit weights include tires & power chute.
TRACTOR PTO HORSEPOWER REQUIREMENTS
PTO horsepower requirements are based on most normal dairy or beef rations. Horsepower require- ments may vary depending on the ration or material to be mixed.
The PTO horsepower requirements shown may not reflect adequate tractor size for towing the mixer, refer to tractor weight requirements for these recommenda- tions and transporting safety precautions for additional tractor and towing requirements.
| MODEL | PTO HORSEPOWER | ||
5032/42 | 65 - 90 AT 540RPM | |||
5055 | 85 |
|
| |
5073 | 130 AT 1000 RPM |
|
| |
| 5085 | 140 AT 1000 RPM |
| |
50100 | 150 AT 1000 RPM |
|
DRAWBAR ATTACHING SYSTEM
Adjust tractor drawbar and/or the mixer clevis hitch so that the mixer is approximately level. The top of the drawbar should be
8 - 12" below the tractor PTO shaft. Adjust the drawbar horizontally so that the hitch pin hole is (14” - 16") 14” for 540 RPM
HYDRAULIC REQUIREMENTS
Dual hydraulic outlets are required for operating the door and the slide tray or power chute. If your tractor has only a single set of ports, then the manual diverter or electric selector valve option should be ordered. If the power chute is used, the tractor hydraulic system must supply a minimum of 15 GPM at 2000 PSI. On units with power chute option, the chute hoses may be difficult to connect due to the chute weight on the lift cylinder. Lift weight off chute cylinder to connect hoses.
12