4.Adjust the cutting height on the wing mower so that it cuts at the same height as the tow vehicle mower. Adjust each corner of the wing mower so that the distance form the smooth surface to the bottom edge of the deck is equal to the cutting height minus 5/16”. The mower blade cutting edge is 5/16” above the lower edge of the deck.
Note: To mow in the lower half of the cutting range, set the front caster axles in the bottom setting and set the
Note: After the cutting height has been set, be sure to tighten the pivot bolts securely to eliminate free pivoting of the front casters or rear axles. Snug the four bolts just beyond the height adjust bolt so the front casters and rear axles can be adjusted up and down but cannot move from side to side.
D.STARTING ENGINE
Set parking brake on tow vehicle. Attach wing mower tongue to tow vehicle.
Do not start wing mower unless it is attached to the tow vehicle. For Models H60T & C60K:
Set the choke to the desired position.
Set the throttle lever in the start position at about half throttle. The mower blades clutch will engage as the engine comes up to speed. The mower blades clutch engages at 1850 RPM.
Start engine and allow engine to warm up.
Adjust the choke to off.
Adjust engine speed to full throttle to fully engage the mower blades clutch.
Clutch overheating or failure may occur if engine is not run at full speed in heavy load conditions.
The engine full speed setting with mower blades running is 3350 RPM.
For Model H60H:
Set the throttle lever in the choke position to set the choke. (The choke is located beyond the full throttle detent position.)
8
