Kuppersbusch USA EKI 407.0M installation instructions Clips, Bracket, Instructions for assembly

Instructions for assembly

Dimensions in mm

Clips

•Drive the clips into the worktop cut-out at the intervals indicated. It is not necessary to adjust the height due to the horizontal stop.

•Important: The horizontal drive of the clips must be flush with the worktop (avoid the risk of fractures).

•Position the hob according to the illustra- tion on the left side (a), align it (b) and insert the clips (c).

•Screws may be used to fasten the clips.

Important:

There is a risk of breakage if the hob is canted or subjected to stress during installation!

Minimum distance to adjacent walls

Cut-out dimension

Outer dimensions of the hob

Cable routing in rear wall Installation height

Bracket

•Insert the hob and align it.

•From the bottom, insert the brackets with screws in the holes provided for fastening the brackets, align the brackets and screw them tight.

•Tighten the screws with a hand screw driver only; do not use a battery-operated screw driver.

•In the case of thin worktops make sure that the brackets are correctly positioned. A metric screw (A) must be used on the bracket to balance it.

Important:

There is a risk of breakage if the hob is canted or subjected to stress during installation!

Minimum distance to adjacent walls

Cut-out dimension

Outer dimensions of the hob

Cable routing in rear wall

Installation height

30