Instructions for assembly
Electrical connection
•Statutory regulations and the connection specifications issued by the local power supply company must be strictly observed.
•Any superfluous cable must be removed from the installation area beneath the appliance.
•Make sure that the local mains voltage is the same as the volt- age on the rating label.
•The induction hob has been fitted with a connection cable in the factory.
•The appliance is supplied ready to plug in. It should be con- nected only to a properly protected wall socket.
•If damaged, the Customer Service must replace the connec- tion cable installed with a special connection cable.
•The
•Full protection against accidental contact must be ensured on installation.
Power supply
Mains voltage: 220 - 240V~,
Component rated voltage: 230 - 240V
Technical data
Hob dimensions |
|
|
|
|
Height/ Width/ Depth . . | . . . . . mm | 50 x 450 x 519 | ||
Cooking zones |
|
|
|
|
front | Ø cm / kW | 16/ 1,4 |
|
|
rear | Ø cm / kW | 25/ 2,3 |
|
|
Hob total | . . . . . kW | 3,7 |
|
|
|
| |||
|
|
|
|
|
Start of operation
Once the hob has been installed and the power supply has been provided (mains connected) an automatic test of the controls will be carried out and information for Customer Service will be indi- cated.
Important: No items may be on the touch control sensor keys when the appliance is being connected!
Briefly wipe over the surface of the hob with a sponge and soapy water and then dry with a clean cloth.
31
