Kuppersbusch USA EKS 804.2 manual Your appliance at a glance, Using the cook top, Heat indicators

Your appliance at a glance

1 Normal cooking zone

2 Heating indicators

3 Dual circuit cooking zone

4 Regulators for cooking zones

5 Frying zone

EKS 304.1

EKS 604.2

–Press down the regulator and turn to the de- sired cooking level.

Φ Ideally, start cooking using the highest set- ting and continue at a lower setting.

.

Cooking level Suitable for

0switching off

1-3heating up, keeping warm, defrosting

4-5steaming, soaking, cooking

6-8frying, deep-fat frying

9heating large quantities, searing

Frying or dual-circuit cooking zone

As a rule, only the smaller cooking zone diameter is heated. However, when ysing frying pans and large saucepans, you may decide to switch on the outer cooking zone circuit.

Switching the frying or dual-circuit zone on:

–Turn the control clockwise as far as it will go. You’ll feel a slight resistance.

–Then set it back to the re-

quired cooking level.

Switching the frying or dual-circuit zone off:

–Turn the control to “0” briefly.

–Then set it to the required cooking level.

EKS 804.2

Using the cook top

ΦWhen you turn the cooking surface on, you will hear a short buzzing noise as it heats. This is design-specific and does not affect the quality and

operation of the appliance.

Selecting a cooking level

Each cooking zone has its own regulator. 9 cook- ing levels are marked on every regulator. You can also select intermediate settings.

Switching the cooking zone off

– Turn the regulator to the “0” position.

Heat indicators (1)

[CAUTION! The indicator can fail (defective light bulb). This means you won’t be warned when the cooking zones are hot. Have the light bulb

replaced immediately!

Each cooking zone has a corresponding heat indicator: it’s positioned identi- cally to the cooking zone.

The indicators remain on while the cooking zones are still very hot – even after they have been switched off.

4 EKS