![Using the cooking zones](/images/new-backgrounds/69967/6996711x1.webp)
Using the cooking zones
Please note the safety instructions!
Subsequent to initial connection and after a power failure “'%0” will appear briefly in the LED displays. Rotating, circling symbols will then be indicated. This means that various sensors have been checked automatically and that the touch sensitivity has also been newly set.
Touch the “off” sensor in order to confirm that there were no objects on the cooking zones or on the sensors. These symbols will be switched off immediately if there are no objects on the sensors. Otherwise remove any objects and disconnect the cooking zone briefly from the mains (fuse) once again.
Important!
There may not be any objects on the sensors or on the cooking zones while the sensor sensitivity is automatically being set.
Switching the honeycomb cooktop on
ΦBefore you start to use a cooking zone, put the cook top into the stand- by mode.
– Touch the
– Each cooking zone can now be operated individually.
Cooking zones on which a pan has been placed will indicate a small “u”.
The
–if no cooking zone is activated within 20 seconds (after 10 seconds an acoustic buzzer will indicate that the appliance will switch off after another 10 seconds) or
–if it remains unused for one minute after operation.
The cooking levels
There exist 9 cooking levels.
The cooking setting required can be activated by means of the plus or the minus sensor. It is shown in the display.
ΦIn order to be able to set a cooking level, a pan suitable for the
or
detection must have been placed on the cooking zone or the
Φ
The “0” setting remains visible for approx. 2 seconds after
Cooking level | Suitable for |
|
|
heating up, keeping warm defrosting | |
|
|
steaming, soaking, cooking | |
|
|
frying, | |
|
|
9 | heating large quantities |
|
|
6 | Users Guide - EKWE/EKWH - USA |