Flue assembly - Mounting the hood body
• Position the upper chimney section and fix the upper part to the frame using the 2 screws 12c
(2,9 x 9,5) provided.12c
• Similarly, position the lower chimney section and fix the lower part to the frame using the 2 screws 12c (2,9 x 9,5) provided.
Recirculation version | 8b |
•Make sure that the outlet of the extension pieces 14.1 is horizontally and vertically aligned with the chimney outlets.
•If this is not the case, remove the lower chimney section and adjust the position by either revers-
ing the connection extension pieces 14.1, then reassemble as described previously.
• Fit the directional grids 8a - 8b in their housings 12f making sure that the directional symbols are towards the top. Also make sure that they are correctly inserted in the connection extension pieces 14.1.
Before fixing the hood body to the frame:
•Remove the grease filters from the hood body.
•Remove any activated charcoal filters.
•From below, use the 4 screws 12f (M6 x 10) provided to fix the hood body to the frame.
ELECTRICAL CONNECTION
•Connect the hood to the mains through a two- pole switch having a contact gap of at least 3 mm.
•Remove the grease filters (see paragraph Maintenance) being sure that the connector of the feeding cable is correctly inserted in the socket placed on the side of the fan
•Connect the control connector Cmd.
• Place the connector in the junction box 24 and | 24 |
close it using the 2 screws 12e (2,9 x 9,5) | 12e |
provided. |
|
• Fix the junction box to the hood body using the 2 |
|
screws 12c (2,9 x 6,5) provided. |
|
• For the recirculation version, fit the activated |
|
carbon odour filter. |
|
• Replace the grease filters. |
|
| 12c |
8a
Cmd
GB |
| 10 |
