FIXING THE FRAME
• Loosen the two screws fastening the lower chimney and remove this from the lower frame.
• Loosen the two screws fastening the upper chimney and remove this from the upper frame.
If you wish to adjust the height of the frame, proceed as follows:
• Unfasten the eight metric screws joining the two columns, located at the sides of the frame.
•Adjust the frame to the height required, then replace all the screws removed as above.
• Insert the upper chimney stack from above, and leave | 1 | 1 | |
|
| ||
| it running free on the frame. |
|
|
• | Lift up the frame, fit the frame slots onto the screws |
|
|
| up to the slot end positions. |
|
|
• | Tighten the two screws and fasten the other two | 2 | 2 |
| screws provided with the hood. | ||
|
|
| |
Before tightening the screws completely it is possible to adjust the frame by turning it. Make sure that the screws do not come out of their seats in the slotted holes.
•The frame mountings must be secure to withstand the weight of the hood and any stresses caused by the occasional side thrust applied to the device.
On completion, check that the base is stable, even if the frame is subjected to bending.
•In all cases where the ceiling is not strong enough at the suspension point, the installer must provide strengthening using suitable plates and backing pieces anchored to the structurally sound
parts.Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 mm, the choice of which is left to the installer.
• | Fix the pipe using the pipe clamps 25 provided. | 25 |
• | Remove any activated charcoal filters. |
RECIRCULATION VERSION AIR OUTLET
•Push fit connection 15 onto the air outlet.
•Insert the connection extension pieces laterally 14.1 in connection 15.
Should the central reinforcing piece of the frame somehow interfere the chimney air outlet grille, it is possible to unscrew it and to place it in another screw hole set.
15
14.1
GB |
| 9 |
