Kustom 66 Dart owner manual Dart Back Panel

66 DART™ Back Panel

12.) Power Switch - This switch turns on and off the AC power to the amp.

13.) AC Power Cord Receptacle/Fuse - AC power cord can be removed for easy storage and replacement if damaged. Insert the AC cord (provided) firmly into the AC receptacle. NOTE: Replace the AC power cord if protective jacket is damaged or ground pin is damaged or removed.

The fuse is located in a fuse tray just below the receptacle. Replace only with same size and type. For your convenience, a spare fuse is located inside the fuse tray toward the front. To replace fuse, remove AC power cord. Remove fuse tray by pulling the tab located above the fuse symbol away from the receptacle.

14.) SPEAKER - This jack is used to deliver the amplified signal to an external speakers. Total minimum load is 8 ohms. Do not use a load lower than 8 ohms. Damage to the amplifier may result. The amplifier ’s internal speaker is disconnected when this jack is used.

15.) LINEOUT - This is a 2-conductor 1/4” line output jack. This will allow an external amplifier or mixing board to be supplied with the signal from this amp.

16.) HEADPHONE - This is a 3-conductor stereo jack. The amplifier ’s internal speaker is disconnected when this jack is used.

17.) CD/TAPE INPUT - This is a 3-conductor 1/4” jack that allows playback from a Compact Disc or Tape player.

5