Kustom owner manual KPM8420 Specifications

KPM8420

Specifications

Model	KPM8420	8 Channel Dual Powered Mixer
Output Power	200W per channel	4 Ohms @ 5% THD
	180W per channel	4 Ohms @ 0.4% THD
Frequency Response	20HZ-20kHz	Actual response is tailored to speaker cabinet for
		accurate acoustical response.
Total Harmonic Distortion	Less than 0.4%	Measured at 1VRMS (0dBv) at record output, effects
		send, preamp output, or Main output.
Hum & Noise	-115dB	Mic Input, Rs=150 ohm, 20-20kHz
	-55dB	Residual Noise, all level controls 0% (minimum)
	-45dB	Nominal System Noise, all level controls at 50%
	All Measurements made at 1kHz
	90 dB	Mic to Power Amp (Ch 1 - Ch8) Pad Off
	77dB	Mic to Power Amp (Ch 1 - Ch8) Pad On
System Gain	72dB	Line to Power Amp (Ch 1 - Ch8) Pad Off
	60dB	Line to Power Amp (Ch 1 - Ch8) Pad On
	36dB	Playback to Power Amp
	50dB	Mic to Main out, Pad On
	50dB	Mic to Monitor out, Pad On
	50dB	Mic to Record out, Pad On
Crosstalk	70dB	Channel to Channel, 1kHz
Input Channel Equalization	Special curve that adjusts Bass, Mid, and Treble frequencies
Master Equalization	100 to 10kHz, 7 Band, 1 Octave Graphic, all ±12dB
	Two 24 bit DSP modules, 8 effects per module.
Digital Effects	Module 1:
	Small room, Large room, small hall, large hall, chorus, chorus reverb, slapback, echo
	Module 2:
	Short room, Med room, small hall, Med hall, chorus, chorus reverb, chorus hall, short delay
Phantom Power	+40V	Applied to all Mic inputs when active
Footswitch	Digital effects On/Off	and Channel ON/OFF (playback remains active)
	Recommended: KUSTOM model KAC-FS-202 (dual switch with LEDs)
	USA/Canada	120VAC/60Hz, 300W nominal
Power Requirements	Europe	230VAC/50Hz, 300W nominal
	UK	230VAC/50Hz, 300W nominal
	Australia	240VAC/50Hz, 300W nominal
	Japan	100VAC/50-60Hz, 300W nominal
Dimensions	mm/kg	292 (Height) x 495 (Width) x 305 (Depth), 15.6kg
	Inches/Pounds	11.5 (Height) x 19 (Width) x 12.1 (Depth), 34.4 lbs

12