34
35
ON
OFF
POWER
FUSE:T2A/250V
ACFUSE
120V 60Hz160W
ATTENTION
CAUTION
RISQUEDECHOCELECTRIQUE-NE PASOUVRIR
RISKOFELECTRICSHOCK
DONOTOPEN
DESIGNEDINUSA MADEINCHINA
SERIALNUMBER
MODELwAv210
CAUTION
CHASSISSURFACEHOT SUPERFICEDECHASSIS CHAUDE
ATTENTION
FOOTSWITCH LEFT
LineOut
RIGHT
LineOut PREAMP
Out
POWER
AMPIN
PREAMP
Out
POWER
AMPIN
LEFT RIGHT
33
29
30
31 32
TAB
Power ON/OFF Switch:
AC Power Cord Receptacle:
Footswitch Jack
Left and Right Line Out:
Left and Right Preamp out:
Left and Right PowerAmp In
:
:
TurnsAC power on and off.
Insert theAC cord (provided) firmly into the AC
connector. NOTE: Replace the AC power cord if
protective jacket is damaged or ground pin is
damaged or removed.
The fuse is located in a housing just below the
receptacle. Replace only with same type and size.
Toremove the fuse, remove AC power cord and
pull out on the tab above the fuse symbol
located on the fuse carriage. Placethe new fuse in
the carriage clip and re-insert. NOTE: Toprevent
an electrical hazard, DO NOT replace fuse
without using the fuse carriage. Replace the fuse
carriage if lost or damaged before re-inserting the
AC power cord.
Plug Footswitch into this connector using the
supplied cable. If the cable is lost or damaged, a
standard CAT5 cable can be used. CAT 5 cables
can be purchased at your local retail electronic and
computer stores.
These ¼” mono jacks deliver the signal going to the
speakers at an unbalanced line level. The main
purpose of these jacks is to deliver line level
outputs to external sound reinforcement devices
such as powered monitors or speakers. They will
not drive external non-powered speakers. To
prevent an undesirable feedback oscillation, do not
use these jacks on signal processors or effects that
will be using thepower amp input jacks.
These ¼” mono jacks deliver an unbalanced line
level output from the preamp and digital effects.
The main purposeof these jacks is to send a signal
to the input of third party signal processors or
effects that will be using the power amp input
jacks. These jacks do not interrupt signal flow from
the preamp to the power amp.
These ¼” mono jacks allow the left and right power
amplifiers to be used with an external line level
input. The main purpose of these jacks is to receive
the return signal from a third party signal processor
or effect. NOTE:When used, these jack will
interrupt the signal flow from the preamp to the
power amp.
FUSE:
8
Rear Panel