7-30 Using the Operation Panel
Unit (Selecting the unit of measurement)
1Press Z.
2Press U or V repeatedly until >>Unit appears. The unit of
measurement can be selected between millimeters and inches. The
current unit of measurement is displayed (the default setting is mm).
3Press [OK]. A blinking question mark (?) appears.
4Select mm or inch using U or V.
5Press [OK].
Set the dimensions of the paper as described in the next section.
Entering the Width and Length
Enter the paper size for X Dimension and Y Dimension as shown in
the figure.
1When the unit of measurement is set, press V.
>>X Dimension appears (the paper width setting).
2Press [OK]. A blinking cursor (_) appears.
3Press U or V to increase or decrease the value of the figure where
the cursor is blinking and display the desired width.
Acceptable paper widths are 140 to 216 mm (5-1/2 to 8-1/2 inches).
4Display the paper width and press [OK].
5When the width is set, press V. >>Y Dimension appears (the
paper length setting). Set the desired length in the same way as the
width.
Acceptable paper lengths are 210 to 356 mm (8-1/4 to 14 inches).
6Display the paper length, press [OK].
7Press [MENU]. The display returns to Ready.
>>Unit
? mm
X Dimension
Y Dimension
140 to 216mm
(5-1/2 to 8-1/2 inches)
210 to 356mm
(8-1/4 to 14 inches)
>>X Dimension
216 mm