2.0 INSTALLATION
IMPORTANT: PLEASE READ THIS SECTION BEFORE USING THE SPX20
2.1 INSPECTION AND UNPACKING
The SPX20 has been carefully packed at our factory in a carton designed to withstand handling in transit. Should the unit appear to have been damaged in transit notify your dealer immediately and do not discard any of the packing. The carton should contain -
•The SPX20 unit
•Power cord
•Operator Manual (this book)
2.2 OPERATING ENVIRONMENT
The SPX20 is designed to operate between 0 and 50°C
2.3 CE STANDARDS AND THE LOW VOLTAGE DIRECTIVE (LVD)
The SPX20 has been designed to meet the latest Electromagnetic Compatibility (EMC) regulations. However we recommend you do not operate the unit close to strong emitters of electromagnetic radiation such as power transformers, motors, mobile telephones or radio transmitters.
The unit should only be connected to a power supply of the type described in 2.4 POWER REQUIREMENTS or as marked on the unit. The unit must be earthed for safe operation. Disconnect the mains supply before removing any cover.
2.4 POWER REQUIREMENTS
There is a mains fuse located inside the unit which is accessed by removing the cover. This fuse is for protection against unit faults and as such will not normally need replacing. If you think you have a power related problem please refer to your dealer.
The voltage and fuse rating have been factory set for -
230V | 50mA | UK |
220V | 50mA | Republic of Korea |
115V | 100mANorth America | |
• The correct voltage and fuse rating is indicated on the rear panel.
Page 4
